Paul,
Have we not overlooked the diameter, pitch and offset of the case holes?
(Memories of S/Line...)
Cheers for now, 73,
Adam VA7OJ/AB4OJ
-----Original Message-----
From: tentec-bounces@contesting.com
[mailto:tentec-bounces@contesting.com]On Behalf Of Paul Christensen,
Esq.
Sent: Thursday, May 22, 2003 10:05
To: tentec@contesting.com
Subject: Re: [TenTec] Eccentric display?
I haven't yet seen anyone mention the orientation of the Phillips screws on
the rear panel. Are all the screw slots aligned
perfectly with one another or...is this another area for improvement?
-Paul, W9AC
----- Original Message -----
From: "Bill ROWLETT" <kc4atu@yahoo.com>
To: <tentec@contesting.com>
Sent: Thursday, May 22, 2003 12:57 PM
Subject: Re: [TenTec] Eccentric display?
> If you check out the other info on the site, you will
> see that the screen shots look fine. It is your
> downloaded image. I play with graphics all day and the
> way things very from machine to machine is enought to
> cause a man to drink at times.
>
> Have a good day.
>
> 73, Bill kc4atu
>
> __________________________________
> Do you Yahoo!?
> The New Yahoo! Search - Faster. Easier. Bingo.
> http://search.yahoo.com
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|