k6se@juno.com wrote:
>
> After I stored my CW filter center frequencies in USER1 and USER2, I took
> advantage of the band stacking feature and stored 4 frquencies/modes/BW
> settings in each band stacking register for all 9 bands.
>
> Today I did a USER1 recall and lost all of the band stacking I did (which
> takes a bit of time). I did the band stacking thing for all 9 bands
> again and then did a USER1 store.
>
> Happily, when I now do a USER1 recall, the band stacking register are
> intact.
>
> If you use the USER feature, the moral of the story is:
>
> After you make any changes in your setup, press and hold the USER button
> to store everything including your changes.
The four-per-band stacking registers are a nice touch but needed a bit
of work. I suggested that bandwidth information be retained in the
registers and was happy to see this implemented in V 1.341. I've now
lobbied to have the PBT and AGC settings retained in the registers in a
later update and have suggested that the 100k and 10k tuning steps be
done away with in favor of two additional settings between 10Hz and
100Hz.
Dave Heil K8MN
|