Is there a link to the new information of the 60M allocation?
When will it be open for us in the US?
Will the N4PY software support a the 60M band?
Jim W7ANF
----- Original Message -----
From: "N4PY" <n4py@qvssoftware.com>
To: <tentec@contesting.com>
Sent: Thursday, May 15, 2003 5:21 AM
Subject: Re: [TenTec] Re: CW on 60M
> That's not true. Sending an audio tone would be indistinguishable from a
> CW carrier and in clear violation of the rule.
>
> Carl Moreschi
>
> ----- Original Message -----
> From: "Roy Koeppe" <royanjoy@ncn.net>
> To: "Ten Tec Reflector" <tentec@contesting.com>
> Sent: Thursday, May 15, 2003 7:44 AM
> Subject: [TenTec] Re: CW on 60M
>
>
> > About...
> >
> > "BTW, you CAN send CW on these bands... you would just need to have
> > audio
> > keying on a USB transmission... which is supported via some soundcard
> > software like MixW. It certainly meets the letter of the law."
> >
> > A single frequency audio tone fed into the mike jack of a SSB
> > transmitter produces a normal CW signal at the antenna. I guess that was
> > tongue in cheek though...
> >
> > 73, Roy K6XK/0
> >
> >
> > _______________________________________________
> > TenTec mailing list
> > TenTec@contesting.com
> > http://lists.contesting.com/mailman/listinfo/tentec
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
|