thanks allan, that will do it 73 johnku3g
"A. Sewell N5NA" <n5na@arrl.net> wrote:John,
I can't tell you about the lamps but the info from the filter instruction
sheet is:
"Note the 3 pin connector beside the filter slot and the "jumper" 2 pin plug
installed. Pin one is closest to the filter. For models 216, 217, or 219 -
Jumper pins 1 and 2 to set the proper IF Gain. For models 218 or 220 -
Jumper pins 2 and 3 to set the proper IF Gain."
This is for an Omni V, VI or VI+. Hope this helps.
73,
Alan N5NA
----- Original Message -----
From: "JOHN"
To:
Sent: Sunday, May 11, 2003 8:19 AM
Subject: [TenTec] hey gang
> does anyone know what the lamps that are used in an omniv for the "s"
meter are? and also what is meant when installing the narrow filter in the 9
mhz ifthat the gain select jumper, i do not have the instructions that came
with the filterthanks john ku3g
>
> ---------------------------------
> Do you Yahoo!?
> The New Yahoo! Search - Faster. Easier. Bingo.
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
---------------------------------
Do you Yahoo!?
The New Yahoo! Search - Faster. Easier. Bingo.
|