Mark,
There is a 'Keep Alive' feature where the Pegasus will go out of TX if it
doesn't receive communication from the host computer within a short time. As
documented in the Programmer's Reference Guide (PRG). They intended to allow
that delay to be programmable. However, I spoke to Gary Barbour at TT about
it as there is no mention of how to set the time in the PRG. He replied that
the timeout period is fixed. In my experience it's on the order of a second
or less. The 'Keep Alive' can be enabled or disabled. I don't think that
would work for your transmit TO.
73,
Mark
----- Original Message -----
From: <w4chl@mindspring.com>
To: <tentec@contesting.com>
Sent: Friday, May 09, 2003 0:36 AM
Subject: [TenTec] Transmit timeout in Pegasus ?
> I suspect that it is fuzzy brain more than anything else, but is there a
> transmit timeout setting on a TenTec Pegasus ? If so, where is it
> settable ?
>
> Cheers & 73s de Mark W4CHL
>
> Chapel Hill NC USA http://rtpnet.org/parc
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
|