Perry,
This only proves that despite the nay sayers, the Scout is NOT dead.
73,
Frank, K4VMO
----- Original Message -----
From: <w8au@sssnet.com>
To: <tentec@contesting.com>
Sent: Wednesday, May 07, 2003 12:24 PM
Subject: Re: [TenTec] Curious
> At 09:00 AM 05/07/2003, ARDUJENSKI@aol.com wrote:
> >The SCOUT is set up for 600 OHM headsets. there are not mods and 600 ohm
> >headsets are not readily available except thru surplus.
>
> I have not recently read the Scout manuals that I received many years ago,
> but I don't recall any specification for earphone Z since the audio
> output is direct. (no transformers)
>
> It provides more output to the earphones with decreasing load, of course.
> When used with external speaker, it works great.
> Most old complaints were about too much audio when using 4-8 ohm
> fones, and series R was added. In my case I use Telex headsets that
> have about 100 ohms Z and no problem.
>
> Interesting to hear this thread again, after all these years.
>
> Perry w8au
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
>
|