Check the PIN diodes in the receive bandpass circuit.
I had a lightning hit on my Peg. and had to replace
the finals. After doing so I could not get any power
except on the bands below 20M. A PIN diode in the 20M
receive bandpass circuit was shorted.
73, Dave VE1ADH
--- Jeff Griffin <kb2m@comcast.net> wrote: > I
haven't used my Peg in a week or so. Last night I
> powered it up to work
> some 17m. I found out that it won't tx on 17m and
> above, in CW, SSB , or
> tune mode. The tx light comes on, but no output.
> This happen's with several
> s/w control programs. Has anyone had the same
> problem? I'm in a bit of a
> hurry as my Orion is due here tomorrow! So I would
> like to work on this
> tonight. I have a set of the schematics, any ideas?
>
>
> Heard this on local repeater yesterday....
>
> "I've narrowed it down to two rig's, the Mark 5
> field, and the ProII. I
> really like the ProII because it's really neat that
> you can change the
> display background, the guy at HRO changed it to a
> skyline of Tokyo, that
> was really cool..."
>
> On my mother's grave, I'm not making this up......
>
> 73 Jeff kb2m
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
______________________________________________________________________
Post your free ad now! http://personals.yahoo.ca
|