At this point I don't know for sure. But I think there will be an RX ANT
connection on a board in the Orion that can be brought out to the spare
jack. This should be very similar to the mod we made for the Pegasus and
Jupiter.
It's too bad, with all the great things on the Orion that no AUX Receiver
jack was put on it.
Carl Moreschi N4PY
Franklinton, NC
----- Original Message -----
From: "Mark Erbaugh" <mark@microenh.com>
To: <tentec@contesting.com>
Sent: Thursday, April 17, 2003 8:31 PM
Subject: Re: [TenTec] Computer Contol of the Orion
> Carl,
>
> Your new software sounds interesting. I'll be looking forward to seeing
it,
> although I doubt I'll have an Orion before the TT hamfest this fall. Do
you
> already know how to get a receive signal from the Orion to the RX340? I
did
> a quick scan of the manual and it doesn't look like there's a sub-receiver
> antenna connection.
>
> 73,
> Mark
>
> ----- Original Message -----
> From: "Carl Moreschi" <n4py@earthlink.net>
> To: <tentec@contesting.com>
> Sent: Thursday, April 17, 2003 11:29 AM
> Subject: Re: [TenTec] Computer Contol of the Orion
>
>
> > Although tentec has not yet released the programmer's manual for the
> Orion,
> > they have stated that everything you can do from the front panel will be
> > controllable from software. I am planning on releasing an Orion version
> of
> > my software as soon as possible that will control the Orion without
front
> > panel usage. It will also feature using the rx340 with the Orion. The
> > RX340 has some advantages for SWL'ing because of sync AM and wider
> filters.
> > I am planning on implementing what I will call "Smart VFO" which will
> > examine the VFO A and VFO B frequencies and choose the best receiver for
> > each VFO. This will make it transparent to the operator that the main
> Orion
> > receiver is ham bands only.
> >
> > Carl Moreschi N4PY
> > Franklinton, NC
> > ----- Original Message -----
> > From: "Mark Erbaugh" <mark@microenh.com>
> > To: <tongaloa@alltel.net>; <tentec@contesting.com>
> > Sent: Thursday, April 17, 2003 3:11 PM
> > Subject: Re: [TenTec] Computer Contol of the Orion
> >
> >
> > > Jupiter -> Pegasus
> > > RX340 -> RX331
> > > Orion -> ???
> > >
> > > ----- Original Message -----
> > > From: "tongaloa" <tongaloa@alltel.net>
> > > To: <tentec@contesting.com>
> > > Sent: Thursday, April 17, 2003 10:57 AM
> > > Subject: Re: [TenTec] Computer Contol of the Orion
> > >
> > >
> > > > Good question.
> > > > Their RX331 and RX340 are essentially the same RX.
> > > > Perhaps they will release a small rack mount version
> > > > of the Orion, no front panel, for about 60% of the
> > > > price. Ethernet with two way digital audio would be nice.
> > > > I'd buy one.
> > > >
> > > > -Bob
> > > > ah7i, ah7i/4
> > > >
> > > > Mark Erbaugh wrote:
> > > > > I'm assuming that TT hasn't released the Programmers' Reference
> Guide
> > > (PRG)
> > > > > for the Orion, but any thoughts / rumours about how much of the
> > Orion's
> > > > > front panel controls will be able to be controlled from software?
> > Would
> > > the
> > > > > Orion be suitable for remote operation where the front panel is
not
> > > used?
> > > > >
> > > > > 73,
> > > > > Mark
> > > > >
> > > > > _______________________________________________
> > > > > TenTec mailing list
> > > > > TenTec@contesting.com
> > > > > http://lists.contesting.com/mailman/listinfo/tentec
> > > > >
> > > >
> > > >
> > > >
> > > > _______________________________________________
> > > > TenTec mailing list
> > > > TenTec@contesting.com
> > > > http://lists.contesting.com/mailman/listinfo/tentec
> > > >
> > >
> > > _______________________________________________
> > > TenTec mailing list
> > > TenTec@contesting.com
> > > http://lists.contesting.com/mailman/listinfo/tentec
> >
> > _______________________________________________
> > TenTec mailing list
> > TenTec@contesting.com
> > http://lists.contesting.com/mailman/listinfo/tentec
> >
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
|