Well, it seems a master reset cures
the problem. I just hadn't done that
after I installed 1.337. I reset the radio
a few minutes ago and that cured it.
Thanks,
Mike - WB4HUC
Austin, TX
http://home.austin.rr.com/mjnewell/station2.html
----- Original Message -----
From: "Phil Howlett" <w9xx@ivwnet.com>
To: <tentec@contesting.com>
Sent: Sunday, April 13, 2003 8:58 AM
Subject: Re: [TenTec] Orion receiver audio gone after 'TUNE' button pressed
> Same version; this radio doesn't do that.
>
> W9XX
>
>
> ----- Original Message -----
> From: "Michael A. Newell, WB4HUC" <mnewell1@austin.rr.com>
> To: "tentec" <tentec@contesting.com>
> Sent: Sunday, April 13, 2003 8:34 AM
> Subject: [TenTec] Orion receiver audio gone after 'TUNE' button pressed
>
>
> Three times in a row now I've turned the radio on,
> and the first thing I've done is press the TUNE button
> for a few seconds. When I press it again to turn it
> off, neither receiver audio can be heard.
>
> All the other functions work: menus, antenna buttons,
> vfo buttons, etc., there's just no audio from either
> receiver.
>
> I'm using version 1.337 of the firmware, but this
> problem may not be related to a particular firmware
> version.
>
> Can anyone else check this out?
>
> Just turn the rig off (or off then back on) then press
> the TUNE switch to activate the transmitter.
>
> Then press TUNE again to turn off the transmitter
> and see if either receiver audio is there or not.
>
> Thanks.
>
> 73,
>
> Mike - WB4HUC
> Austin, TX
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
|