That's a testament to the performance of the RX-340's audio stage without the
need for a dedicated IF output.
When a bandwidth of 16 kHz is selected on the 340, the audio response is ruler
flat that far out and then hits a brick wall. And,
I've measured the low-end response down to near DC on both the AC and
DC-coupled audio output connectors...absolutely amazing
fidelity capabilities from the RX-340.
-Paul, W9AC
----- Original Message -----
From: "Mark Erbaugh" <mark@microenh.com>
To: <tentec@contesting.com>
Sent: Friday, April 04, 2003 11:20 AM
Subject: [TenTec] RX340 and DRM
> TenTec just published instructions on the what's new part of their website
> for setting up the RX340 (no additional hardware required) to use with the
> DRM software. Has anyone tried this yet? The DRM software costs 60 euro's
> for essentially a beta copy and I'm not sure I want to buy it if I won't get
> any use out of it.
>
> 73,
> Mark, N8ME
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
|