Between you two guys I fixed it!!!! For a non-electrical engineer this feels
like nuclear science and a small tracing like this is a HUGE success! Thanks
Ed and Tom!!!!!!!!!!!
You guys are GREAT!!!
----- Original Message -----
From: "Ed Tanton" <n4xy@earthlink.net>
To: <tentec@contesting.com>
Sent: Saturday, March 01, 2003 5:10 PM
Subject: RE: [TenTec] no voltage to 1.8 filter?
>
> >///snip
> >then U22 is working correct and the
> >problem has to be wiring.
> >
> > Tom/W4BQF
>
> ///snip
>
> Not necessarily Tom... one or both of Tim's OMNI VI PIN diode(s)
> associated with that filter could be bad, and it would still act as you
> describe. If the levels associated with the other PIN diodes when
> selected-and when NOT selected-are the same as those for the non-working
> filters' PIN diodes, then the PIN diode(s) should be the cause-as an OPEN.
>
>
>
> 73 Ed Tanton N4XY <n4xy@earthlink.net>
>
> Ed Tanton N4XY
> 189 Pioneer Trail
> Marietta, GA 30068-3466
>
> website: http://www.n4xy.com
>
> All emails <IN> & <OUT> checked by
> Norton AntiVirus with AutoProtect
>
> LM: ARRL QCWA AMSAT & INDEXA;
> SEDXC NCDXA GACW QRP-ARCI
> OK-QRP QRP-L #758 K2 (FT) #00057
>
> --------------------------------------------------
> "Suppose you were an idiot ...
> And suppose you were a member of
> Congress... but I repeat myself."
> --Mark Twain
> --------------------------------------------------
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
|