Better yet, bring in a 230 volt service and put one supply on one leg and
the other supply on the second leg. They share the same neutral. This
provides outstanding regulation on the primary side.
73
Bob, K4TAX
----- Original Message -----
From: "Lane Zeitler" <ku7i@hotmail.com>
To: <w9wis@charter.net>; <tentec@contesting.com>
Sent: Friday, November 22, 2002 2:29 PM
Subject: Re: [TenTec] RE: Herc II Power Supply Redux
>
>
>
>
> If you can, run each Astron supply off of a different 120vac main. This
will
> give better line regulation.
>
> Lane
> ku7i
>
>
> >From: "Michael Melland" <w9wis@charter.net>
> >To: tentec@contesting.com
> >Subject: [TenTec] RE: Herc II Power Supply Redux
To: <tentec@contesting.com>
> >Date: Fri, 22 Nov 2002 14:21:35 -0500
> >
> >Thanks everyone who sent information and advice. I decided to purchase
two
> >RS-70M Astron supplies after finally getting the straight dope on them
and
> >how to utilize the sensing system (yes... they are set up to do this,
> >apparently Astron needs to educate their tech support staff a little
> >better). Looks like a very safe... and RF quiet system.
> >
> >BTW I found the RS-70M's for $249 at Adventrade so the cost isn't too far
> >off what a used 9420 would end up costing.
> >
> >Mike
> >
> >
> >--
> >Michael Melland, W9WIS
> >Winneconne, WI USA
> >_______________________________________________
> >TenTec mailing list
> >TenTec@contesting.com
> >http://lists.contesting.com/mailman/listinfo/tentec
> his
>
> _________________________________________________________________
> Add photos to your messages with MSN 8. Get 2 months FREE*.
> http://join.msn.com/?page=features/featuredemail
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
|