Jeff,
Are you having a problem with the TX audio or the RX audio? The audio input
to the Pegasus, even on the ACCY input is actually at mic levels (5 mV). You
need some heavy attenuation. I'm currently using a 10k pot across the
output, with the Pegasus begin fed across the slider and ground.
Mark
----- Original Message -----
From: "Jeff Griffin" <kb2m@arrl.net>
To: <Tentec@contesting.com>
Sent: Saturday, November 09, 2002 19:35 PM
Subject: Re: [TenTec] PSK31 with the Peg
> > > Is there anyway to lower the output level of the accessory jack? I was
> > > setting my Peg up for PSK31 today and it is overdriving my soundcard.
> I'm
> > > having a difficult time adjusting the output audio.
>
> I tried....
>
> 1. try putting a 600 ohm resistor across audio out to ground.
>
>
> 2. I'd suggest making a "T" type attenuator. 10K ohms series, 1K ohm to
> ground, and 10K ohms series. That should take care of it.
>
> Neither of this worked (I can't believe # 2 didn't show any improvement)
.
> I'm just off the bottom of the Volume control slider, and best IMD report
I
> can get is a 14, with some side bars. Other then that ,599 100%
copy....I'm
> putting out about 15 watts...Anyone have any other suggestions. Thank's to
> all for the suggestion's so far...
>
> 73 Jeff kb2m
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
|