Jeff,
For some reason, the output level on the ACCY jack is about twice that of
the LINE OUT jack and is really too high for a computer soundcard as you
have seen. Depending on the software you are using, you can adjust the line
out level which would reduce the level on the ACCY jack. However, it will
also reduce the level of the speaker output. You're best bet is to either
use the LINE OUT jack or if you want to use the ACCY jack you'll need to
build some padding into the interface. Try putting a 600 ohm resistor across
audio out to ground.
73,
Mark
----- Original Message -----
From: "Jeff Griffin" <kb2m@arrl.net>
To: <Tentec@contesting.com>
Sent: Saturday, November 09, 2002 16:48 PM
Subject: [TenTec] PSK31 with the Peg
> Is there anyway to lower the output level of the accessory jack? I was
> setting my Peg up for PSK31 today and it is overdriving my soundcard. I'm
> having a difficult time adjusting the output audio. It is do-able, but
just
> a tad from off, in the windows soundcard volume control. I would like it
to
> be somewhere in the middle of the soundcard's adjustment range. I also
tried
> to use the line out, but the VOX doesn't seem to work off of it.
>
> 73 Jeff kb2m
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
|