I picked up a new Omni V at Dayton with a 961 PS that apparently had been
dropped at some point. There were a couple dents from inside the case where
the transformer had broken loose, and one of the circuit boards was twisted
on its mount.
My question . . . for some reason, I decided to measure the output voltage
of this device, and it read over 16 volts (yikes!) I hope I didn't do any
major damage to the rig. Anyhow, there are two variable resistors inside
with thumb wheels on them . . . one of them obviously controls the output
voltage and the other controls . . . . WHAT ? ? ?
Any help would be greatly appreciated . . . I turned the one and nothing
happened . . . and then I found the one that controlled the voltage down to
13.8v . . .
73 de Rick, WQ8Q
|