Steve, WD5HNI;
A single line with RCA plugs on each end connect from NO jack on rear of
756 to the NO jack on the Titan. This permits relay keying only.
For QSK, follow instructions in the Titan Manual.
Good Luck,
Jim Miller, K4SQR
http://www.comteksystems.com
4-Square Experts, Stack Yagi
& Remote Antenna Switching Systems
On Sat, 08 Dec 2001 15:54:01 -0600 hogman@ev1.net writes:
> Need some help on getting the Titan to key up using the Icom 756!
> My
> Icom hr has only one outgoing keying line, but the Titan requires
> two
> lines! Why seems a bit silly for that! Yes I know the PTT/VOX
> plug
> needs to used, but it still doesnt key the amp! And my manual
> here
> doesnt seem to cover it very well!
> Any tips would be greatly appreciated!
>
> thanks, Steve/WD5HNI
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
Jim Miller, K4SQR
http://www.comteksystems.com
4-Square Experts, Stack Yagi
& Remote Antenna Switching Systems
|