I'm not sure what "too wide" on cw means....unless its clicks or hum
modulation. For clicks, make sure you're not driving it too hard.
Increasing the drive beyond the point at which the ALC light comes on
can cause spurious outputs, according to TT. For hum, make sure that
there are no AC power supplies too close to the PTO. PTO's are
susceptible to magnetic fields and an AC fields will modulate your
signal. I tried to stack my Corsair on top of the power supply and
remote VFO once...made all the cw sound rough.
73,
Bob WB2VUF
W2AGN wrote:
>
> On Saturday 10 November 2001 17:06, you wrote:
> > Just got an OO Advisory Notice that my Omni C was apparently too wide on
> > 40M (CW). I can't figure out what could be wrong, but obviously something
> > is.
> >
> > Any suggestions?
> >
> > Corey (KF0UN)
>
> --
>
> Check it out independently. OO's are NOT "Official." There have been some
> unable to tell the difference between a wide signal and overloaded receiver.
> Or, you might have QRmed him, and he is "getting even." Check it out.
> --------------------------
> John L Sielke W2AGN
> w2agn@pobox.com
> http://www.qsl.net/w2agn
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
|