Corey,
I certainly agree with John. Have someone you can trust listen and give you
an evaluation.
73,
Troy, W6HV
----- Original Message -----
From: "W2AGN" <w2agn@pobox.com>
To: "Corey Chaney" <jcoreyc@yahoo.com>; <tentec@contesting.com>
Sent: Saturday, November 10, 2001 2:36 PM
Subject: Re: [TenTec] Too wide a signal....
> On Saturday 10 November 2001 17:06, you wrote:
> > Just got an OO Advisory Notice that my Omni C was apparently too wide on
> > 40M (CW). I can't figure out what could be wrong, but obviously
something
> > is.
> >
> > Any suggestions?
> >
> > Corey (KF0UN)
>
>
> --
>
> Check it out independently. OO's are NOT "Official." There have been some
> unable to tell the difference between a wide signal and overloaded
receiver.
> Or, you might have QRmed him, and he is "getting even." Check it out.
> --------------------------
> John L Sielke W2AGN
> w2agn@pobox.com
> http://www.qsl.net/w2agn
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
|