While I attempted to thank each respondent individually, I want to publicly
say thanks to those that provided help; Tony, W4FOA, Stuart, K5KVH, and
Jerry, K0CQ. Looks as if I have some solid pointers on how to approach the
problem. Thanks again and 73,
Troy, W6HV
----- Original Message -----
From: "Dr. Gerald N. Johnson, electrical engineer" <geraldj@isunet.net>
To: <w6hv@surfbest.net>
Cc: <TenTec@contesting.com>
Sent: Thursday, November 08, 2001 2:06 PM
Subject: Re: [TenTec] Corsair II digital readout
> Check the 5 volt power to the digital readout microprocessor and replace
> any electrolytic bypass capacitors in the module. Try the keyer, its in
> the same computer chip. Tighten the board mounting screws to be sure the
> grounds are solid.
>
> 73, Jerry, K0CQ
>
> --
> Entire content copyright Dr. Gerald N. Johnson. Reproduction by
> permission only.
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
|