Certainly on the newer Centurions there is no issue of "hot switching" -
you can QSK key through the keying loop on any Ten-Tec (or newer Yaesu, I
think) rig, or you can key the amp and let it key the rig. I used the
latter method when I first got my TT amp and it was flawless - keyed very
nicely. Later, when I hooked my Centurion to my Omni VI+ keying loop, it
was also flawless. I really liked my Centurion.
73, Duane
Duane A. Calvin, AC5AA
Austin, Texas
ac5aa@juno.com -or- ac5aa@austin.rr.com
Day: dacalvin@us.ibm.com
--------- Forwarded message ----------
From: "Larry Kayser" <kayser@sympatico.ca>
To: <tentec@contesting.com>
To: <tentec@contesting.com>
Date: Tue, 30 Oct 2001 15:42:01 -0500
Subject: [TenTec] Re: Centurion amp questions
Message-ID: <001c01c16183$9c34a370$0a00a8c0@threelakes.ca>
References: <200110301703.f9UH39Z01037@contesting.com>
Greetings:
I have had my Centurian for about 5 years now, works good and is
consistent.
I did manage to have the HV power transformer fail, after thinking about
it
and doing some tests I suspect it was just the luck of the draw, the
thing
failed and went short circuit inside the windings. TT replaced the
transformer promptly at a reasonable cost.
The Pride tubes have given good service, I run QSK but choose not to use
the
internal Centurian keying system as I will accept no distortion of the CW
keying, I use a timed system to key the relays so they never close or
open
hot. I find the amplifier is excellent value.
I hope you find that you have a similar experience if you get one.
Larry
VA3LK
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|