Here is the procedure that I use to assure an optimum fit for the band
modules:
Remove the knobs. Remove the top and bottom covers. Remove the 4 screws
that hold the sides of the front panel to the chassis. Loosen the two
nuts on the control shafts.
Now plug in a band module. Install and tighten the 4 side screws on the
front panel. Tighten the control nuts. Reinstall the covers and knobs.
73,
Bob WB2VUF
Stuart Rohre wrote:
>
> I believe the original Bob who posted on Scout display jumping around later
> posted he found bad plug in connection of the band modules, he could not
> plug them in all the way.
>
> This could be a mechanical problem of the guide and slot used on the
> modules, and I sent him some things to check and fixes for tight modules,
> mainly you put a Little grease on the track to ease them in!
> 73,
> Stuart K5KVH
|