More details.
These are specific observations with my 238 tuner while running some 1200 to
1500 watts of power, using a center fed 1/2 wave dipole fed with 1/2
electrical wavelength of RG-213 coax. The antenna is resonate at about
3950. While using the tuner to achieve a low SWR at frequencies below 3600
no problem, at frequencies above 3800 no problem. HOWEVER, between 3600 and
3800 using a "key down" mode such as RTTY, the SWR would rise rapidly.
Retuning did corrected the problem. But then after 2 or 3 minutes in standby
the SWR was back up. As I transmitted then SWR came down. I.E. heating
and cooling of some component(s).
With the cover off of the tuner, I carefully transmitted for 1 min, turned
the transmitter off and touched each component. When you find the right
one.....OUCH! It was very hot. Removed it and replaced it with a
transmitting type capacitor of the same value. These are mica capacitors
and are about 1.75" long x 1.5" wide, and about 0.5" thick. There is a
screw terminal at each end for connection. These are rated a 1KV .......but
have a RF current rating of some 2 amps.
Problem solved.
73
Bob K4TAX
----- Original Message -----
From: "Duane A Calvin" <ac5aa@juno.com>
To: <tentec@contesting.com>
Sent: Monday, October 01, 2001 1:03 PM
Subject: Re: [TenTec] Model 238 Tuner problems?
>
> Since a couple of folks have mentioned it I should add that I'm not using
> the balun. This is strictly coax-to-coax matching. One antenna is a
> Butternut HF2V which I run on 160m (500W max), 80m, 40m, 15m and
> sometimes 17m. The other ant is a G5RV Jr. which I use on 30m, 20m, 12m
> and 10m.
>
> So far, most responses have suggested checking common coax (I have 2
> jumpers from amp, to Autek meter, to 238). Good idea since I'd like to
> replace the mini-8X with full sized RG-8U. One response indicated
> catastrophic failure of caps at the Z-switch (10m high power), and
> another was a 2nd hand report of someone having solder melting problems
> when used with wire antennas.
>
> Duane
>
> Duane Calvin, AC5AA
> Austin, Texas
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
|