I use both the Goldline and the Heil headset with the HC-5. I had to go into
the Pegasus (same board as the Jupiter) and crank up the mike gain so the
relative setting is meaningless but there is more than sufficient gain to
use the mikes. I use about 30% compression and in order to get the VOX to
work have to get the red ALC light to blink fairly frequently. Don't worry
about the settings. Get some on the air reports and if it sounds good and
you do not have any splatter then all is OK.
Tom, W7QF
> -----Original Message-----
> From: tentec-admin@contesting.com [mailto:tentec-admin@contesting.com]On
> Behalf Of WmLB@prefer.net
> Sent: Sunday, September 02, 2001 13:14
> To: Tentec@contesting.com
> Subject: [TenTec] Jupiter /Heil Question
>
>
> I have a question or two with anyone using the
> Jupiter with a Heil BM-10 or Goldline.
>
> I have only had the rig for a couple of days but it
> seems that it takes relatively more mic gain with
> this rig to achieve the appropriate ALC
> indications then it it with my Yaesu rig. Of course
> with the Yaesu I was used to having the ALC reading
> on the meter. (not a little red lamp)
>
> So...
>
> Approximately where do you have your mic gain set?
> And ....when you are using processing.. how much
> compression are you using (I would guess maybe no
> more then 20% or so)?
>
> Thanks
>
> Bill, W6WLB
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
|