Hi David -- I have modified the Omni V making it the Omni V.9 using
Carl (N4PY's) firmware modification. This gives it a "real" RS-232
port. I am using Logger software. If you're interested and would
like more information look at:
http://www.hal-pc.org/~kg5u/OmniV9.html
Others may have had success with the stock Omni V and other software.
Good luck!
73,
Rick
VE7ASR
---------- ORIGINAL MESSAGE ----------------
To: <tentec@contesting.com>
> Date: Fri, 25 May 2001 08:34:01 -0400
> From: David Perrin <dbp@conknet.com>
> Subject: [TenTec] OMNI V using RS-232
> I have not used the RS-232 port on the OMNI V with success. The
> serial cable is wired as in the manual. Is a level converter
> needed as with ICOM? Address? Port speed? Flow control? Any hints
> and software ideas for the OMNI V would be appreciated. I am/was
> expecting to use "YP log". Ideas?
> 73 de Dave K1OPQ here or at k1opq@arrl.net
--
FAQ on WWW: http://www.contesting.com/FAQ/tentec
Submissions: tentec@contesting.com
Administrative requests: tentec-REQUEST@contesting.com
Problems: owner-tentec@contesting.com
|