Hello Tom:
The remote encoder is plug and play, no other set up required. If you have
any RF in the shack, it may pick it up and cause various problems. A snap on
ferrite usually cures the problem...better yet, a good ground and antennas
in the clear is the best approach.
enjoy
73, Patrick
K9PF
----- Original Message -----
From: "MYCROFT" <WA3HVP@intergrafix.net>
To: <TenTec@contesting.com>
Sent: Friday, May 18, 2001 8:27 PM
Subject: [TenTec] TT 302J Encoder/Keypad
>
> Hi Gang. TT just sent me the 302J encoder/keypad and cable. My "Juniper"
> radio is in there service dept so I can't try it out. I know that it plugs
into
> the remote jack on the back of the Juniper - did anyone ever get an
instruction
> sheet with there 302? OR if I plug it in, when I get it back, does it
just
> run itself?
>
> Best to all - Tom WA3HVP
>
>
> --
> FAQ on WWW: http://www.contesting.com/FAQ/tentec
> Submissions: tentec@contesting.com
> Administrative requests: tentec-REQUEST@contesting.com
> Problems: owner-tentec@contesting.com
>
>
--
FAQ on WWW: http://www.contesting.com/FAQ/tentec
Submissions: tentec@contesting.com
Administrative requests: tentec-REQUEST@contesting.com
Problems: owner-tentec@contesting.com
|