Another very simple method that works well is to invert the phase of one ear
piece on your headphones. This must be done at the speaker terminals by
swapping the "+" and "-" leads. If you find this to be helpful, a DPDT
switch can oftentimes be installed in the ear piece shell, allowing you to
turn the effect on and off.
-Paul, W9AC
----- Original Message -----
From: "Ken Kinyon - W7TS" <W7TS@Qwest.net>
To: <tentec@contesting.com>
Sent: Sunday, April 01, 2001 1:30 AM
Subject: RE: [TenTec] binaural CW?
>
> I did this about 15 years ago with headphones and a divider network meant
> for stereo speakers. I think the crossover was 450HZ I put the high
freqs
> in my left hear and the lows in my right to match the tuning dial on my
> receiver at the time.
> The effect was quite dramatic. It makes it much easier to copy different
> signals without retuning.
> 73,
> Ken W7TS
>
> -------------------
> Kenneth E. Kinyon
> 34 Princeton Circle
> Longmont, CO 80503-2106
> Voice/fax (303) 684-0037
> E-mail: W7TS@Qwest.net
> W7TS@qsl.net
> W7TS@arrl.net
> ALPCA #8339
> ARRL-LM
> -------------------
>
>
> --
> FAQ on WWW: http://www.contesting.com/FAQ/tentec
> Submissions: tentec@contesting.com
> Administrative requests: tentec-REQUEST@contesting.com
> Problems: owner-tentec@contesting.com
>
--
FAQ on WWW: http://www.contesting.com/FAQ/tentec
Submissions: tentec@contesting.com
Administrative requests: tentec-REQUEST@contesting.com
Problems: owner-tentec@contesting.com
|