TenTec
[Top] [All Lists]

[TenTec] OMNI VI @ qrp level ?

To: <tentec@contesting.com>
Subject: [TenTec] OMNI VI @ qrp level ?
From: ac5aa@juno.com (Duane A Calvin)
Date: Tue, 20 Mar 2001 09:51:48 -0600
My VI+ will go to somewhere around 0.15 watts output (interpolated) as
measured by my Autek WM-1.  The power seems to rise roughly linearly when
the PWR knob is increased.  Don't know if this helps or not

        73,   Duane   AC5AA


On Tue, 20 Mar 2001 10:16:08 -0500 Dennis Terribile/WR4i
<wr4i@mindspring.com> writes:
> 
> I do a lot of my cw operating at 5w or less on the QRP freq. so when 
> I was 
> told the VI goes to "0" that was another "selling point" to picking 
> up this 
> used VI. Here's the problem. I can use the "tune" button and drop 
> the power 
> to zip but when I send cw  it "jumps" back to over 5wts!  I can also 
> watch 
> the meter on the VI and see its jumping to 10w or more. On my old 
> Argosy I 
> can set the power to mw level and it stays there when keyed.  Is 
> this normal?
> Thanks for any/all comments.
> Dennis /WR4i
> Ivy,Va
> 
> 
> --
> FAQ on WWW:               http://www.contesting.com/FAQ/tentec
> Submissions:              tentec@contesting.com
> Administrative requests:  tentec-REQUEST@contesting.com
> Problems:                 owner-tentec@contesting.com
> 
> 


Duane A. Calvin, AC5AA
Austin, Texas
ac5aa@juno.com -or- ac5aa@austin.rr.com
Day:  dacalvin@us.ibm.com

--
FAQ on WWW:               http://www.contesting.com/FAQ/tentec
Submissions:              tentec@contesting.com
Administrative requests:  tentec-REQUEST@contesting.com
Problems:                 owner-tentec@contesting.com


<Prev in Thread] Current Thread [Next in Thread>