TenTec
[Top] [All Lists]

[TenTec] INRAD mod to OMNI VI+, INRAD web page info needed

To: <tentec@contesting.com>
Subject: [TenTec] INRAD mod to OMNI VI+, INRAD web page info needed
From: jkoppi@pclink.com (Joseph Koppi)
Date: Tue, 27 Feb 2001 19:51:21 -0600
Took a while, but I finally found the site here:

http://www.qth.com/inrad/


Joe Koppi, W0SU
St. Paul, MN

----- Original Message -----
From: "Bob Wilderman" <dlrwild1@voicenet.com>
To: <tentec@contesting.com>
Sent: Tuesday, February 27, 2001 6:53 PM
Subject: [TenTec] INRAD mod to OMNI VI+, INRAD web page info needed


>
> Anyone know where I can find the INRAD web page?? I would like to explore
> the possibility of doing the INRAD mod to the OMNI VI+.
>
> What  changes ore physically made to the OMNI VI+? Is there soldering,
board
> swap-outs, snap in filters or new boards to replace the Ten Tec boards,
any
> new alignment to be done etc. Are there photos of the mods on the INRAD
web
> site? How much time is required to make the needed changes? What is the
cost
> of the mods? Can anyone with or without lots of technical skills make the
> changes? I am not too handy with a soldering iron.
>
> 73's
> Bob Wilderman, K3SRO
> dlrwild1@voicenet.com
> Lansdale, PA
>
>
> --
> FAQ on WWW:               http://www.contesting.com/FAQ/tentec
> Submissions:              tentec@contesting.com
> Administrative requests:  tentec-REQUEST@contesting.com
> Problems:                 owner-tentec@contesting.com
>
>


--
FAQ on WWW:               http://www.contesting.com/FAQ/tentec
Submissions:              tentec@contesting.com
Administrative requests:  tentec-REQUEST@contesting.com
Problems:                 owner-tentec@contesting.com


<Prev in Thread] Current Thread [Next in Thread>