Clark,
It almost sounds like some sort of heat sensor tripped. Once it cools down,
it resets and the amp is ready to run again.
I've never owned the Herc, so you'll have to dig in the schematics.
GL es 73 de Tom, K4NR
----- Original Message -----
From: Clark Savage Turner <csturner@falcon.csc.calpoly.edu>
To: <tentec@contesting.com>
Sent: Sunday, January 21, 2001 1:57 AM
Subject: [TenTec] Herc II questions again...
> Now, I just experienced the amp shutting down on me twice during an SSB
> transmission. It was on peaks, the amp shut down with no fault
> indication, the "overdrive" light was not lit, but the bandpass filter LED
> went out totally, and the amp would not come back up for a minute or so,
> even though I power cycled it a couple of times.
--
FAQ on WWW: http://www.contesting.com/FAQ/tentec
Submissions: tentec@contesting.com
Administrative requests: tentec-REQUEST@contesting.com
Problems: owner-tentec@contesting.com
|