[TenTec] OMNI VI to Herc II interface cable

[csturner@falcon.csc.calpoly.edu (Clark Savage Turner)]

On Sun, 21 Jan 2001, Steve Baron - KB3MM wrote:

> Isn't the pinout in the OMNI VI manual ?

I found it with some help.  It is a little side figure next to the TX
audio board diagram.  Page number differs in my OMNI VI manual that the
one referenced to me, but I did find it in the lower right corner of the
diagram :-) .

Clark
WA3JPG


--
FAQ on WWW:               http://www.contesting.com/FAQ/tentec
Submissions:              tentec@contesting.com
Administrative requests:  tentec-REQUEST@contesting.com
Problems:                 owner-tentec@contesting.com