I don't know about the OMNI C but the OMNI D has a jumper
in the back for the external VFO.
If that jumper is loose or disconnected or the external VFO
is disconnected, the display will read 9.0000.
Check the jumper first.
Bill
-----Original Message-----
From: Phil Sikes <psikes@whidbey.net>
To: tentec@contesting.com <tentec@contesting.com>
To: <tentec@contesting.com>
Date: Tuesday, January 02, 2001 14:02 PM
Subject: [TenTec] Omni C problem
>
>Hello to the group. My recently acquired Omni C has developed a
>problem I hope someone can help me with. When powered up the display
>reads 9.0000 on 20M and up. 30M reads 91.0000 and 40 and 80 read
>10000. I know the 9.0000 is the oscilator freq. but any ideas on why
>the display is reading it? The rec. works FB, just don't know where I
>am!!
>
>73 - Phil
>N7UX
>
>-- Phil Sikes, psikes@whidbey.net on 01/02/2001
>
>
>--
>FAQ on WWW: http://www.contesting.com/FAQ/tentec
>Submissions: tentec@contesting.com
>Administrative requests: tentec-REQUEST@contesting.com
>Problems: owner-tentec@contesting.com
>
>
--
FAQ on WWW: http://www.contesting.com/FAQ/tentec
Submissions: tentec@contesting.com
Administrative requests: tentec-REQUEST@contesting.com
Problems: owner-tentec@contesting.com
|