Hi All,
just an update with regard to my fault on tx i have still not
managed to cure it,Still going wild when i key down,output going on and off.
But i have narrowed it down now to where i think the problem is,in the
driver
and final pa stages.I have checked out the power suppy,it's ok.The VSWR and
output
filters are ok and all the switching is ok,ie:- the T and R voltages are
doing what
they are supposed to be doing,on when they should be and off when they
should be !
So this coming weekend i'll check out the final stages of the final amp!
just
hope i can find the fault there.
With regard to reply's from Ten Tec,i emailed to the Sales address and
recieved
a reply within about a week.Unfortunatly being in England it's not to
practical to phone Ten Tec
and so the info i gave them by email was probably lacking in the detail i
could have gone into
over the phone,so they were not able to be of much help.
One last reuest,does anyone have a copy of the Manual for the Century 22
?.i have a copy
but there is a page missing,it is of a block diagram,with the boards
numbered and the inter-wiring
shown,would be grateful if any one could email me a copy of that page ?
Many thanks and when it's fixed i'll keep you posted what the problem
has
been..
Regards
Bill G4KKI
Member of RSARS,FISTS,RIG.
Website http:\\www.g4kki.freeserve.co.uk
--
FAQ on WWW: http://www.contesting.com/FAQ/tentec
Submissions: tentec@contesting.com
Administrative requests: tentec-REQUEST@contesting.com
Problems: owner-tentec@contesting.com
|