Match the tones.... Holding in the CW button causes it to inject a tone into
the audio chain that matches the offset you have selected... When you
adjust the tuning dial so that the incoming audio note matches the CW-button
tone, you are zero beat with his carrier frequency...
Denny
----- Original Message -----
From: "Roy Koeppe" <royanjoy@ncn.net>
To: "Ten Tec Reflector" <tentec@contesting.com>
Sent: Monday, November 27, 2000 3:03 PM
Subject: [TenTec] Re: Zero beating with the OMNI-6+
>
> Asked,
>
>
> "Hey, guys, i'm re-reading my Omni 6+ manual. This rig does a lot! I
> still can't seem to figure out the CW zero beat procedure. I know i
> need
> to hold in the CW button while tuning in the CW station. But do i match
> the tone of that station or do i zero out the tone to get on his exact
> freq??"
>
> Bob Mauro, Mauro@Idt.Net Amateur Radio Station KZ2G
>
>
> Bob,
>
> As with all modern transceivers, you simply match the tone of the
> received station to that of your side tone.
>
> 73, Roy K6XK Iowa Outback
>
>
>
>
> --
> FAQ on WWW: http://www.contesting.com/FAQ/tentec
> Submissions: tentec@contesting.com
> Administrative requests: tentec-REQUEST@contesting.com
> Problems: owner-tentec@contesting.com
>
--
FAQ on WWW: http://www.contesting.com/FAQ/tentec
Submissions: tentec@contesting.com
Administrative requests: tentec-REQUEST@contesting.com
Problems: owner-tentec@contesting.com
|