You might consider CAREFULLY changing out the center capacitors to higher
values to narrow the bandwidth - then if you don't like the very narrow
bandwidth, replace the original caps and go back to the 500 Hz original
bandwidth.
Values? Try increasing ONLY the interior cap values by roughly 30% of their
current value to start. Leave the "outer" cap values the same. You can also
do this by tack-soldering very small caps of appropriate value across the
bottom of the filter to see if it works well or to determine the final
narrowness you like in the filter. (Love those TenTec open construction
filters)
Bill K5BDZ
--
FAQ on WWW: http://www.contesting.com/FAQ/tentec
Submissions: tentec@contesting.com
Administrative requests: tentec-REQUEST@contesting.com
Problems: owner-tentec@contesting.com
|