As I recall from a QST review, there was a problem of induced ac when the
supply was close to one side of the radio, causing the transmit signal to
sound bad. You might try putting the power supply on the other side of the
radio and far away as possible.
----- Original Message -----
From: "Mike Siegel" <ki6pr@elite.net>
To: <tentec@contesting.com>
Sent: Wednesday, September 06, 2000 11:06 AM
Subject: [TenTec] 961 P/S Xmit Noise?
>
> Greetings All,
>
> When I first purchased my Omni-V (many years ago), it came with a Model
961
> P/S. I vaguely remember some reports of noise generated by the supply.
>
> Since then, I have been using the supply to operate a Paragon (for several
> years, in fact). Recently, I started receiving reports of RF on my audio.
> After some checking around, it appears to be only on certain frequencies,
> and the problem seems to clear up (mostly) when the P/S is moved away from
> the rig.
>
> Is there another fix, or mods to reduce the problem? The P/S cable is only
> so long, so I can only get so much separation from the rig. Other
> suggestions?
>
> Thanks & 73,
> Mike KI6PR
> El Rancho R.F., CA
>
>
>
> --
> FAQ on WWW: http://www.contesting.com/FAQ/tentec
> Submissions: tentec@contesting.com
> Administrative requests: tentec-REQUEST@contesting.com
> Problems: owner-tentec@contesting.com
>
>
--
FAQ on WWW: http://www.contesting.com/FAQ/tentec
Submissions: tentec@contesting.com
Administrative requests: tentec-REQUEST@contesting.com
Problems: owner-tentec@contesting.com
|