I have compared the Pegasus I have here to a Yaesu FT-920 and see very
little difference on 28 Mhz. A small amount but signals will have to be
just above the noise level to see any noticeable difference. The general
background noise level is less on the Pegasus which initially would make me
think the sensitivity is less but when signals are present, they were not
that much difference above the noise level, readability almost the same.
I do have to use the attenuator on 75 ssb quite often when the band is good.
Jim K4JAF
----- Original Message -----
From: "Larry Kayser" <kayser@sympatico.ca>
To: <tentec@contesting.com>
Sent: Sunday, August 27, 2000 10:36 AM
Subject: [TenTec] Re: Pegasus upper band rec
>
> Greetings:
>
> I had a total of three Pegasus units here, all performed excellently up to
> 28 mHz, the same sensitivity and signal resolving ability as the Kenwood
> TS-570, ICOM 756 etc. I found that the Pegasus had a small additional bit
> of noise quieting which I attributed to the DSP - but the signals were all
> there as they were in the other receivers available during the test
period.
>
> It might be time for you to look for a bad connector or.....
>
> 73
>
> Larry
> VA3LK
>
>
>
>
> --
> FAQ on WWW: http://www.contesting.com/FAQ/tentec
> Submissions: tentec@contesting.com
> Administrative requests: tentec-REQUEST@contesting.com
> Problems: owner-tentec@contesting.com
>
>
--
FAQ on WWW: http://www.contesting.com/FAQ/tentec
Submissions: tentec@contesting.com
Administrative requests: tentec-REQUEST@contesting.com
Problems: owner-tentec@contesting.com
|