I am using a Heil HC-4 with my Omni-V. I installed the HC-4 element as
a replacement for the original moving coil element in a junk box
desk mike I got at a hamfest. The moving coil element worked fine, but
needed the mike gain in the Omni setting near to max. The Heil
apparently has much more output. Actually I never intended to use the
HC-4 with the Omni because I also have a TT 705, but it suddenly
decided not to work anymore, so I just plugged in the HC-4 as a
temporary measure. Its been there ever since; I get good audio reports
and nobody who knows my voice has ever asked if I changed mikes .....
73 John G3JAG
-------------------------------------------------------------
On 05-Jun-00 Robert Leavitt wrote:
>
> I have been looking at the Heil HM-10 microphone with the HC-4
> element. Has
> anyone used this mic(or any mic with the HC-4 element) with the
> OMNI-D, or
> any Ten-Tec rig for that matter? How well did it perform? What
> connecting
> cables would I need for the OMNI-D?
> You can reply to the list or directly to me at: aa1uz@arrl.net.
>
> Thanks
>
> Drew Leavitt
> AA1UZ
----------------------------------
E-Mail: John - G3JAG <patents@dx0man.prestel.co.uk>
To: <tentec@contesting.com>
Date: 06-Jun-00
Time: 01:01:00
This message was sent by XFMail
----------------------------------
--
FAQ on WWW: http://www.contesting.com/FAQ/tentec
Submissions: tentec@contesting.com
Administrative requests: tentec-REQUEST@contesting.com
Problems: owner-tentec@contesting.com
|