Richard, I run direct from the right output of my sound card to the
acc in on the pegasus with no pad. You may need an adapter to split
off the right channel. Set the mic gain to minimum.
Set the VOX gain to half.
I run the acc output with a stereo cable to the sound card line input.
Set windows mixer volume to half and the wave output to half.
Set windows mixer recording control to full.
You will need to adjust the levels so they do not over load.
Some of this depends on your sound card.
You have to turn on VOX and select the accessory input on the
pegasus. My alc light up on all bands except 10M.
Regards, Jim FitzSimons W7ANF
Richard W. Hemingway wrote:
>
> I have Digiapn running on recieve and would like suggestions on wiring the
> Pegasus for TX. I guess that you run the cable from the line out on the
> sound card to the audio it pin on the accessory jack, through a pad to
> attenuate the TX signal. If you are doing this - how did you do it???
--
FAQ on WWW: http://www.contesting.com/tentecfaq.htm
Submissions: tentec@contesting.com
Administrative requests: tentec-REQUEST@contesting.com
Problems: owner-tentec@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|