No effect at all, Rod. The DC voltage for the electret element
is brought out on a separate pin (4) of the mike connector, so it
would not go to the dynamic element at all. The dynamic mike connects
between pin 1 (mike hi) and pin 2 (ground).
73, Bob WB2VUF
Rod Pruner wrote:
>
> What effect, if any, would the DC voltage at the
> MIC connector of Ten-Tec rigs (Delta II and Scout)
> have on a dynamic mic such as the Kenwood MC-60 ?
> I understand this DC voltage is needed for the
> operation of electret type microphones but would like
> to know how it would effect a dynamic mic.
>
> Thanks and 72/73 to all.
>
> =====
> Rod Pruner - KN3ZOG
> Conyers, GA USA
--
FAQ on WWW: http://www.contesting.com/tentecfaq.htm
Submissions: tentec@contesting.com
Administrative requests: tentec-REQUEST@contesting.com
Problems: owner-tentec@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|