I am using Digipan with the Pegasus and with the RX line in from the
Pegasus to the sound card. I have not wired it up for TX yet (however, I
should have the RIGblaster here by Tuesday and will report on it)
Problem. I have been playing with the software and have loaded some of the
macros. When I put the CQ macro in TX it indicates that it is sending -
but when I try to put it back into RX - it indicated on the bottom status
bar that it is in RX but the waterfall will not come back up until I exit
from the Digipan program and bring it back up.
Am I doing something wrong. Although I don't have the PTT line linked up
and it won't key the Pegasus I thought that the software would react
properly and go back to RX.
Dick, N5XRD
--
FAQ on WWW: http://www.contesting.com/tentecfaq.htm
Submissions: tentec@contesting.com
Administrative requests: tentec-REQUEST@contesting.com
Problems: owner-tentec@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|