I'm not sure what the Pegasus uses to key an amplifier, but most Ten-Tecs
use a relay. The SB-200 may put a higher voltage and current on that relay
(or other circuitry) than is appropriate. A fellow named Harbach makes all
sorts of modifications for the SB-200 and SB-220. I have incorporated ALL
of his modifications into my SB-220 and can vouch for both Harbach and his
products.
You can find his SB-200 modifications at
http://www.harbach.com/reference/harpg2.htm
I suggest you consider installing the SK-200 Soft Key kit to lower the
switching voltage and current required by the SB-200.
Regards, Mike N4NT@charter.net
----- Original Message -----
From: "Bud L. Holman" <bholman@iu.net>
To: <tentec@contesting.com>
Sent: Tuesday, March 28, 2000 8:33 AM
Subject: [TenTec] Connecting Pegasus to SB-200
|
| I am looking for advice on the best way to connect a Pegasus to a
| Heathkit SB-200 linear amp. Does anyone have any experience with this?
| Thanks,
| Bud Holman, WA4ASJ
--
FAQ on WWW: http://www.contesting.com/tentecfaq.htm
Submissions: tentec@contesting.com
Administrative requests: tentec-REQUEST@contesting.com
Problems: owner-tentec@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|