Over the last few months, my 961 power supply has become more finicky, and
now shuts down whenever I turn on my Omni VI. I switched the Omni VI to a
backup supply and it seems to be operating normally.
I have no schematic or owner's manual, so I am in the dark. I note that
there are two (2) potentiometers in the supply. I assume one is for voltage
and the other is to adjust the overcurrent trip point. I suspect that the
overcurrent trip may be too sensitive.
Does anyone have any experience adjusting this, or any advice as to where to
begin looking for the problem?
Thanks and 73 to all,
John Holliman WA5TWL
--
FAQ on WWW: http://www.contesting.com/tentecfaq.htm
Submissions: tentec@contesting.com
Administrative requests: tentec-REQUEST@contesting.com
Problems: owner-tentec@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|