put a load on it....
plug in your mic without the backshell and measure the voltage.
7 volts is not too high....recall that the 705 uses a 9v battery in it when
external power is not available. The only thing separating the two voltage
sources are two diodes; each one isolating one voltage source from the
other.
73,
dale, kg5u
> -----Original Message-----
> From: owner-tentec@contesting.com
> [mailto:owner-tentec@contesting.com]On
> Behalf Of Anthony Bowyer
> Sent: Tuesday, March 07, 2000 15:49 PM
> To: tentec@contesting.com
> Subject: [TenTec] Pegasus Mike Connector power
>
>
>
> Any of you Pegasus owners had reason to check the
> voltage on pin 4 of the mike connector? I happen to
> check it last night, and found that mine's 7 volts
> with no load rather than the 4 in the doc's. Just
> wondered if mine has a problem.
>
> =====
> NT4ZO
> __________________________________________________
> Do You Yahoo!?
> Talk to your friends online with Yahoo! Messenger.
> http://im.yahoo.com
>
> --
> FAQ on WWW: http://www.contesting.com/tentecfaq.htm
> Submissions: tentec@contesting.com
> Administrative requests: tentec-REQUEST@contesting.com
> Problems: owner-tentec@contesting.com
> Search: http://www.contesting.com/km9p/search.htm
>
>
--
FAQ on WWW: http://www.contesting.com/tentecfaq.htm
Submissions: tentec@contesting.com
Administrative requests: tentec-REQUEST@contesting.com
Problems: owner-tentec@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|