Try loosening the screws on the top of the preselector and move the top
frame around some so as to put some friction on the sliding part and
retighten the screws. Usually just loosening the back 2 screws and giving a
slight tug on the top plate toward the front of the rig, holding it in place
then retightening the screws will do the trick. No parts needed.
Steve
N4LQ
----- Original Message -----
From: "Ed & Edna" <edn4pk@vol.com>
To: "TenTec" <tentec@contesting.com>
Sent: Monday, February 21, 2000 6:43 PM
Subject: [TenTec] OmniC
>
> What is the correct way to tighten up the Resonate control ??
> Ed W3NR
>
>
> --
> FAQ on WWW: http://www.contesting.com/tentecfaq.htm
> Submissions: tentec@contesting.com
> Administrative requests: tentec-REQUEST@contesting.com
> Problems: owner-tentec@contesting.com
> Search: http://www.contesting.com/km9p/search.htm
>
>
--
FAQ on WWW: http://www.contesting.com/tentecfaq.htm
Submissions: tentec@contesting.com
Administrative requests: tentec-REQUEST@contesting.com
Problems: owner-tentec@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|