Not sure exactly what you are doing, but if you are in the SSB positions,
you will see no ouput until you modulate or talk into the mic. Give us a
bit more info OM Jim K4JAF
----- Original Message -----
From: Al Patrick <arp@inet4u.com>
To: <tentec@contesting.com>
Sent: Sunday, February 06, 2000 8:19 PM
Subject: [TenTec] Pegasus / 705 mic
>
> >
>
> I can tune the Pegasus and get from very low (< 3 watts) to a full 100
watts with
> about a 1.00 to 1 SWR; however, when I key the mic I always get 0 watts
out! (The
> software interface and the tuner agree on the wattage - except very low
end.) It
> doesn't matter if I press the momentary button or the maintained one. PTT
/ VOX
> switch is in the PTT position. No battery is in the mic, but I installed
one
> temporarily with the same results. All interface indications are that I'm
> transmitting, but with 0 watts out!
>
> What is the next thing to check?
>
> (If it's as simple as the last question I had I'm going to feel real dumb!
<g> )
>
>
>
>
>
> --
> FAQ on WWW: http://www.contesting.com/tentecfaq.htm
> Submissions: tentec@contesting.com
> Administrative requests: tentec-REQUEST@contesting.com
> Problems: owner-tentec@contesting.com
> Search: http://www.contesting.com/km9p/search.htm
>
>
--
FAQ on WWW: http://www.contesting.com/tentecfaq.htm
Submissions: tentec@contesting.com
Administrative requests: tentec-REQUEST@contesting.com
Problems: owner-tentec@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|