TenTec
[Top] [All Lists]

[TenTec] "Thin Audio" From an Omni-6+

To: <tentec@contesting.com>
Subject: [TenTec] "Thin Audio" From an Omni-6+
From: Rosenberg.Eric@orbcomm.com (Rosenberg.Eric@orbcomm.com)
Date: Tue, 1 Feb 2000 10:32:21 -0500


I've recently gotten reports that my audio was "thin" regardless of where I set
the mike gain or processor.

I'm using a stock Omni-6 Plus and a 705 mike.  Could the battery be low?

I tried an old Astatic 10DA (100k ohm impedence, I believe, and probably lower
output) and it seemed better, but hten again, it's hard to judge.   I also use a
Heil proset for contesting, but didn't for this test.

Any thoughts on a solution?

Thanks and 73,

Eric W3DQ
Washington, DC
rosenberg.eric@orbcomm.com



--
FAQ on WWW:               http://www.contesting.com/tentecfaq.htm
Submissions:              tentec@contesting.com
Administrative requests:  tentec-REQUEST@contesting.com
Problems:                 owner-tentec@contesting.com
Search:                   http://www.contesting.com/km9p/search.htm


<Prev in Thread] Current Thread [Next in Thread>