Come to think of it, a strong signal might well overcome the bias on your
diodes.
And you still get coupling from all the associated circuitry.
Mike N4NT@wireco.net
----- Original Message -----
From: "Michael O. Hyder" <N4NT@wireco.net>
To: "Ten-Tec Reflector" <tentec@contesting.com>
Sent: Friday, December 31, 1999 2:03 PM
Subject: Re: [TenTec] Spurs from Omni 6 aux antenna input
>
> Don't you suppose that you get capacitive coupling through 'cut off'
diodes?
> Why would you not?
>
> M
>
> ----- Original Message -----
> From: "N1EU" <n1eu@yahoo.com>
> To: "Michael O. Hyder" <N4NT@wireco.net>
> Sent: Friday, December 31, 1999 12:41 PM
> Subject: Re: [TenTec] Spurs from Omni 6 aux antenna input
>
>
> > Hi Mike,
> >
> > Thanks for the reply.
> >
> > The Omni 6 schematic shows that with the switch in
> > "Main", the conduction path for the aux antenna should
> > be completely cut off since two diodes in the sig path
> > will be reverse biased.
> >
> > Hmmm . . . interesting phenomenon.
> >
> > All the best,
> > Barry
>
>
>
> --
> FAQ on WWW: http://www.contesting.com/tentecfaq.htm
> Submissions: tentec@contesting.com
> Administrative requests: tentec-REQUEST@contesting.com
> Problems: owner-tentec@contesting.com
> Search: http://www.contesting.com/km9p/search.htm
>
>
--
FAQ on WWW: http://www.contesting.com/tentecfaq.htm
Submissions: tentec@contesting.com
Administrative requests: tentec-REQUEST@contesting.com
Problems: owner-tentec@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|