I am happy to see the information on where the info about the mike voltage
is located as I looked for it in isolating a failure in my 14 mos old
omni6+. (on my first call in fone SS contest, there was no indication of
output). I have since determined that it works if I jumper
the hand held tt mikes ground to chassis ground. The gnd pin on the
tt front panel has no continuity to chassis ground. I haven't yet asked
tt for the proper repair. Noticed that there appear to be some ferrite
cylinders on some to leads from the tt front panel mike connector.
I have started a cross-reference list for the omni6+ to help in tracing
circuits from one board to another. I wonder if others have already
done this (besides TenTec!) or are interested. Or am I missing some
means already in place?
alwilliams@olywa.net k7puc
v
-----Original Message-----
From: Dale L. Martin <kg5u@hal-pc.org>
To: Ten-Tec Reflector <Tentec@contesting.com>
To: <tentec@contesting.com>
Date: Wednesday, December 08, 1999 4:33 AM
Subject: Re: [TenTec] Omni VI+ mic input
>
>-----Original Message-----
>From: Alfred Lorona <alforo@megsinet.net>
>>
>>Can anyone tell me how the plus voltage for an electret mic on pin 4 of
the
>>front panel mic connector is derived? Series resistor? What value? I have
>>been unable to find the connector on any of the schematic diagrams in the
>>manual.
>>
>>73, AL e-mail alforo@megsinet.net
>>
>
>
>Hi, Al.
>
>At this time of morning and my age of life, a magnifying glass is very
>helpful--actually, probably helpful at any age when dealing with 8.5x11
>schematics. I've also found different colored highlighters to be very
>effective in tracing the circuit of interest--If I looked for it once, I'll
>likely look for it again!
>
>Check the Main Wiring drawing (in my manual, it's just before page 5-1--a
>fold-out page,
>but not the Logic Board).
>
>The mic jack is at the upper left corner.
>
>The PTT and +Mic leads run together down and across to the 81596 board to
>connector 65. The Control Board (81596) schematic shows the PTT/+Mic
connector
>65 at the top center of the drawing. There you will find how the voltage
is
>derived: from the +Reg (connector 59) through R39, a 470 ohm resistor.
>
>73,
>dale, kg5u
>
>
>
>
>
>
>--
>FAQ on WWW: http://www.contesting.com/tentecfaq.htm
>Submissions: tentec@contesting.com
>Administrative requests: tentec-REQUEST@contesting.com
>Problems: owner-tentec@contesting.com
>Search: http://www.contesting.com/km9p/search.htm
>
>
--
FAQ on WWW: http://www.contesting.com/tentecfaq.htm
Submissions: tentec@contesting.com
Administrative requests: tentec-REQUEST@contesting.com
Problems: owner-tentec@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|