Gary,
It could be RF getting into the power supply
causing
some regulation/modulation problems. I've seen that on
more than one occasion. You could try a toroid on the
power leads and/or wrap them into a tight bundle. I
don't know if you've done it yet or not, but you might
also make sure the negative lead on the power supply
is connected directly to your ground connection.
--- Gary Bernard <W0CKI@netzero.com> wrote:
> Have a Pegasus, been on with it for 2 weeks. Great
> radio and value!! But, very sensitive to RF in or
> near the shack.Won't tune\load with linear on one
> antenna, no problem on the other. In my case it is
> the R6000 vertical with counterpoise mounted almost
> directly above the radio room.(other vertical is150
> feet from the shack) Have done the usual, added
> toroids on all critical leads including the serial
> interface cable, no ground loops I know of. Move the
> R6000???, I think so, any other ideas??
> Regards, Gary W0CKI
>
__________________________________________________
Do You Yahoo!?
Thousands of Stores. Millions of Products. All in one place.
Yahoo! Shopping: http://shopping.yahoo.com
--
FAQ on WWW: http://www.contesting.com/tentecfaq.htm
Submissions: tentec@contesting.com
Administrative requests: tentec-REQUEST@contesting.com
Problems: owner-tentec@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|