superglue
----- Original Message -----
From: <00tlzivney@bsuvc.bsu.edu>
To: <tentec@contesting.com>
Sent: Tuesday, November 23, 1999 12:34 PM
Subject: [TenTec] 301 knob - TenTec logo
>
> OK, I have now gotten my 301 kit encoder to function with my new OMNI VI+
>
> had a couple of minor glitches to solve - one was how to connect the wires
> to the little connector for the encoder - Dale pointed out that the wires
> need to be pressed into the connector so I used a fine-bladed screwdriver
> for that. Then, the radio shack 4 conductor shielded cable several
people
> have recommended proved too big for me to get the cable clamp around. I
> had to cut off a piece of the tab and shave the main body opening bigger.
>
> Now, the remote knob works fine. However, how do I get the TenTec logo
> to stay on the box? The two pins on the back of the logo don't just snap
> into the box, and they aren't threaded so that I use nuts. What's the
> secret?
>
> Terry Zivney, N4TZ/9
> n4tz@arrl.net
>
> --
> FAQ on WWW: http://www.contesting.com/tentecfaq.htm
> Submissions: tentec@contesting.com
> Administrative requests: tentec-REQUEST@contesting.com
> Problems: owner-tentec@contesting.com
> Search: http://www.contesting.com/km9p/search.htm
>
--
FAQ on WWW: http://www.contesting.com/tentecfaq.htm
Submissions: tentec@contesting.com
Administrative requests: tentec-REQUEST@contesting.com
Problems: owner-tentec@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|